There are different categories of warning and error messages:
Warnings, Program execution continues, but there is a problem to be addressed.
Normal Errors, Program execution continues, until the default 101 errors occurs, or the program finishes.
Fatal Errors, Program execution stops, the problem is too severe to continue.
Security Errors, This refers to problems with the software security checking.
Operating System Errors, This refers to things like service denials.
Program Errors, Program execution stops, the problem is too severe to continue. If you get this type of error message, do not spend any time trying to solve the problem, just send us your files. Be sure to follow the protocol for sending files.
WARNINGS:
Q: WARNING: No Objects Selected by Selector 0
Q: WARNING: Table Contains Negative Element Lengths
Q: WARNING: Tension Specified is Less Than Zero H Case
Q: WARNING: Load Attribute Has No match *J1739 *J1759 ?
Q: WARNING: EQUILIBRIUM NOT FOUND WITHIN TOLERANCE
Q: WARNING: No Data For A PICTURE
Q: WARNING: Negative On Diagonal Of Damping
Q: WARNING: You Cannot Do Structural Loads With This Database
Q: Why do I get WARNING: Equilibrium Not Found Within Tolerance
Q: WARNING: Discarding Contour
Q: WARNING: Edge Does Not Have Two Surfaces
Q: WARNING: No Valid Ethernet Address Found
Q: WARNING: No Valid Ethernet Address Found
Q: WARNING: Failed Key Check, Continuing with Minimum Capabilities
Q: WARNING: Fixing Zero On Diagonal Of Stiffness At *X.XXX
Q: WARNING: xxx Sig. Figures Lost At *X.XXX
Q:
What is the reason of the warning
WARNING: Releases Created Element Singularity,
NORMAL ERRORS:
Q: ERROR: Could not Find Close Point In Part PJACKET
Q: ERROR: TANK1 adds negative weight either permeability or definition wrong
Q: ERROR: In Computing Tank Depth
Q: ERROR: No Solution to Ballasting Problem Found
Q: Why do I get ERROR: RAO Computation Did Not Converge when
Q: ERROR: XXX is not a valid option for this command
Q: ERROR: LGROUP *C1A Spans Parts
Q: ERROR: Cannot Compute Offsets for Beam
Q: ERROR: Bad Syntax Encountered - Location of the Trouble is
Q: ERROR: Class XXX Has Bad Segment Lengths
Q: ERROR: $$$$$$ Has Not Been Defined
Q: ERROR: &INTEREST Is Not a Valid Command At This Time
Q: ERROR: Singularity In Stiffness At *X.XXX
Q:
ERROR: Launch Leg Has Offset
FATAL ERRORS:
Q: FATAL ERROR: Solution for Line Cannot Be Found
Q: FATAL ERROR: Bad Time In NUMEVE
Q: FATAL ERROR: Unexpected END OF FILE on Type
Q: FATAL ERROR: Write Failed IOSTAT = xxx Disk Is Probably Full !
Q: FATAL ERROR: File Type PPOUT Has Not Been Defined?
Q:
FATAL ERROR: Nodes Are Not Connected to Rest
SECURITY ERRORS:
Q: SECURITY ERROR: X.XXX Is Not Authorized For This Version
Q:
SECURITY ERROR: Update Is Incompatible With Installation
OS ERRORS:
Q: OS ERROR: Refused to Allocate Space Probably Out Of Swap Space